Generac 0K2267C/0K2267A/0K2267B Evolution Control Panel For Liquid Cooled Generators

Generac 0K2267C Evolution Control Panel replaces all former versions of the Evolution panel including 0K2267A & 0K2267B. You must use this updated C version for all replacements as older versions may NOT work with your generator if it was made after an older panel was discontinued!

*PLEASE READ*

These controllers (and any OEM Evolution Liquid Cooled Controller) do not come programmed from the factory! Because these controllers are used in many sizes and variations of generators, they must have the correct parameters entered to tell the controller what generator it’s connected to.

These controllers REQUIRE programming once installed in the generator and MUST be programmed correctly or damage to the generator, controller, connected loads or any combination of the 3 could occur!! If you are unfamiliar with programming this panel, it’s advised that you contact a local dealer to complete the install for you. If you have questions please ask BEFORE ordering this controller.

Controller will not need to be activated as the original was with an activation code.

Panels should be installed by a qualified technician who can check output voltage and frequency to ensure proper calibration.

Generac replacement parts will also usually fit the following Generac branded generators: Honeywell, Guardian, Siemens, Carrier, Watchdog, Centurion, Eaton & Bryant.

If you need Generac generator troubleshooting support,